Request a call back from Evolution Skateparks by emailing us here
Evolution products are engineered to the highest standards, constructed from the highest quality materials, and designed with an emphasis on safety and practical usage. We often see skate ramps designed and engineered by alternative manufacturers that are simply dangerous or lack quality, attention to detail and correct geometry. Check out the images below:
Poor geometry makes the ramp to ground transfer dangerously steep
Insufficient length of toe-plate make even and positive contact with the ground impossible
All variations of Evolution ramp are fitted with structurally integrated, curved toe-plates that minimise transfer angle, exert downward pressure on the ground, and WILL NOT loosen
The use of cost saving thin guage steel gives rise to impact damage, dangerous edge ‘peeling’ and compromised structural integrity.
The short term financial gains of equipment surfaced in materials not suited to long-term outdoor environments will suffer from rapid deterioration.
Evolution Skate Ramps offer a riding surface composition of 24mm thick, with 4 surface options designed to suit specific applications and environments for maximum durability and low maintenance.
Repetitive grind and impact damage have made these platform surfaces irregular and dangerous. Even the toughest surface material is showing signs of premature failure
Evolution skate ramps fit 3mm galvanised steel wear plates as standard to all areas of platforms and rolling surfaces that are prone to repetitive grinding or stunt peg impact, to maximise riding surface lifespan
Poor design facilitates climbing and the risk of entrapment
An inferior choice of materials has resulted in damage due to insufficient strength
All Evolution safety railings exceed BS recommendations, are exceptionally heavy duty and designed to be continuous in both directions to eliminate entrapment
No steel edge protection has caused significant damage and created a sharp riding surface edge
No steel protection at threshold joints leads to rapid wear and impact related damage that creates sharp edges in direction of travel
Exposed riding surface edges on Evolution ramps are protected by heavy guage steel to eliminate premature wear and damage
These wooden enclosure panels are an easy target for unauthorised tampering and vandalism in addition to rapid deterioration from weathering and impact damage.
The use of cost saving thin guage steel gives rise to unauthorised tampering and vandalism resulting in partial removal or dangerous edge ‘peeling’.
Evolution equipment utilises the heaviest guage pre galvanised sheet available (3x thicker than our competitors), laser cut for precise fitment, and fixed with tamperproof, air compressed fixings.